|
|
User Rank: Newbie
Joined: 9/23/2010
Posts: 3
|
Hi
Just got my new PC with Win7 Prof and a Samsung SH-B083L Bluray-Combo. Installed LightScribe System Software and different labeling software, but always have the same problem: everything seems to look fine until I start printing, then the process starts but takes just about 5 seconds, and then it says "job successfully done" and there is no label on the disk.
I used Intenso LightScribe 1.2 CD-R's and got no error-message, disk and drive were found and ready.Diagnostics tool also found no errors.
any ideas?
|
|
User Rank: Power User
Joined: 9/21/2010
Posts: 295
|
What Labeling software did you install? That's an important part of the equation...
|
|
User Rank: Newbie
Joined: 9/23/2010
Posts: 3
|
atm only the Lightscribe Template Labeler, uninstalled all others.
|
|
User Rank: Power User
Joined: 9/21/2010
Posts: 295
|
Only the Lightscribe Template Labeler? Oh honey.
Listen to burn a LightScribe label you need:
LightScribe System Software + a labeling program* + Physical LightScribe Drive + LightScribe Disc
So, go ahead and reinstall the LightScribe System Software. Here is the link to the download page: http://www.lightscribe.com/downloadsection/Windows/index.aspx?id=810
*You have the LightScribe Template Labeler, so you meet this requirement. And it's my favorite. It's the one that I use.
|
|
User Rank: Newbie
Joined: 9/23/2010
Posts: 3
|
as i wrote in my first post, i of course installed the system software and of course i have a lightscribe drive and disc.
you asked what labeling software i installed, and that is the template labeler.
if it was that easy i wouldn't have asked....
|
|
|
|
